Heewing T1-S Ranger PNP twin-motor FPV airplane
Heewing T1-S Ranger PNP is a twin-motor FPV airplane with a 790mm wingspan, suitable for recreational flying. It follows the popular T1 Ranger model, retaining its compact dimensions and quick assembly, while offering longer wings, a roomier fuselage and a range of design improvements. The package includes a foam carrying case that fits the disassembled airplane including accessories for easy transport.
Compared to the T1, the wingspan has been increased to 790mm and the fuselage length extended from 355mm to 385mm. This provides more space for the battery and electronics. The aileron linkages run along the top of the wing, so the servo arms are protected from impacts during belly landings. The rear section features a quick-release design: during assembly, the vertical stabilizer is installed first, followed by the tail boom; disassembly is done in the reverse order. The wings slide onto a carbon rod and snap into the fuselage, while the wiring connects via a quick connector.
Power is provided by two pre-installed 1406 (3150KV) motors with 3830 propellers, a Heewing 20A ESC with BLHeli_S firmware, and 4.3g micro servos. The power distribution board includes a 5V/3A output for the RC receiver and other electronics. The manufacturer recommends a 4S battery, with takeoff weight ranging from 600 to 950 grams depending on the setup. The center of gravity is located at the protrusion on the underside below the wing and can be adjusted by moving the battery, for which a mounting plate is included. Before the first flight, we recommend calibrating the ESC throttle range.
The model is PNP – motors, ESC, servos and power distribution board are already installed. RC receiver, transmitter, flight controller, FPV video system and battery are not included. Disconnect the power before removing or installing the wings.
Key Features
- Wingspan: 790mm
- Length: 715mm
- Fuselage length: 385mm
- Takeoff weight: 600-950g
- Recommended battery: 4S
- Motor: 2x 1406 3150KV (pre-installed)
- Propeller: 3830
- ESC: Heewing 20A BLS (BLHeli_S, 2-4S)
- Servo: 4.3g FX-4.3G
- Power distribution board: 5V/3A output
- Design: twin-motor, quick-release wings and tail section
- Carrying case: foam, included
Package Includes
- 1x Foam carrying case
- 1x Fuselage with installed electronics
- 1x Left wing
- 1x Right wing
- 2x 1406 motor (pre-installed)
- 1x Horizontal stabilizer
- 1x Vertical stabilizer
- 1x Tail boom
- 1x Carbon fuselage rod
- 1x Accessory bag
- 1x Propeller bag
- 1x Battery mounting plate

















































































Всички DJI Дронове
DJI Lito
DJI Mini 5 Pro
DJI Neo 2
DJI Neo
DJI Avata 360
DJI Avata 2
DJI Mavic 3 Pro
DJI Air 2S
DJI Avata
DJI FPV
DJI Mini 3 Pro
DJI Care Refresh Планове
DJI Matrice 5
DJI Matrice 4
DJI Matrice 400
DJI Dock
DJI Mavic 3 Enterprise
DJI FLYCART 30
DJI FlyCart 100 ТОВАРЕН ТРАНСПОРТЕН ДРОН
Софтуер за индустриални дронове
Професионални камери
Antigravity A1
Детски дронове
Детски дронове и дронове за начинаещи
Батерии за дронове
Корпуси за дронове
Крака за дронове
Мотори/Зъбни колела
Перки / Витла за дронове
Предпазители за перки
Зарядни устройства
FPV дронове
FPV дронове
FPV части
FPV видео антени
Аналогови FPV камери
FPV Батерии
Аналогови VTX
Дигитални FPV системи
Кабели и конектори
FPV Зарядни
Инструменти
Крепежни елементи
FPV Мотори
FPV Перки
Радио Приемници и Антени
Дистанционни и модули
FPV Рамки
FC / ESC / Stacks
FPV GPS Модули
FPV Чанти и кейсове
Самолети
DJI Osmo 360
DJI Osmo Action 6
DJI Osmo Action 4
DJI Mic Mini 2S
DJI Osmo Pocket 4/4Pro
DJI Osmo Pocket 3
DJI Osmo Mobile 8/8P
DJI Osmo Mobile 7
DJI Ronin RS 4 PRO
DJI Ronin RS 3 Pro
DJI RS3 Mini
DJI Ronin 4D
Insta360 X6
Insta360 Luna
Insta360 X4
Insta360 Flow 2 Pro
Insta360 GO 3/3S
Други камери insta360
Резервни части за DJI Tello
Резервни части за DJI NEO / NEO 2
Резервни части за DJI Avata / Avata 2
Резервни части за DJI Spark

Дрон футбол (DroneBALL)




Отзиви
Все още няма отзиви